- An intelligent peripheral – capable of internal filtering to reduce network traffic
- Software configurable to read/write EPC Class 1, EPC Gen 2 and ISO tags
Factory configurable to operate in 865MHz, 869MHz, 915MHz or 950MHz
- Directly monitors and controls presence detectors and signal lights
- Downloadable firmware for migration path to ISO 18000-6c
Joining a diversified line of RFID readers, the Intermec IF4 serial reader is the ideal RFID peripheral for applications where an edge server or Programmable Logic Controller (PLC) is used for process control. The IF4 reduces the communications burden on the network and processing demand on the host PLC.
While reading and writing RFID labels and tags, the IF4 uses an air-interface protocol for filtering out unneeded tag data caused by multiple reads and tags not required for the application.
General purpose input/output (I/O) circuitry enables the IF4 to monitor and/or control peripheral devices while keeping the cost of ancillary equipment and installation down.
After the IF4 controls the selection of appropriate tags for reading, it then combines its pre-configured application parameters with the information from the selected tags in order to activate external sensors as well as control audible and visual indicators.
Country specific power cables.
FCC & ETSI Antennas and cables
Operating Temperature: -20°C to 55°C (-4°F to 131°F)
Storage Temperature: -40°C to 85°C(-40°F to 185°F)
Humidity (non-condensing): 10% to 95%
Shock: 10 G, 11ms, half sine pulse(operating)
Vibration: 1.0 GRMS. 10 to 500Hz, 3 axis (operating)
Length: 19.1 cm (7.5”
Height: 6.6 cm (2.6”)
Width: 13.5 cm (5.3”)
Input: 90-260VAC, 50-60Hz
Output: 9VDC, 2.6ADC
User's Guides and Manuals